MINOLTA 8031 DRIVER

November 5, 2019 By:

The staple case is released. The clock begins ticking. Using the keypad, enter the limit value. The power source requirements are as follows. Remove any misfed paper. The paper feed direction is shown by the arrows in the diagram below. In this case, since the document size cannot be detected and the paper cannot be automatically selected, the paper source must be selected.

Uploader: Faunris
Date Added: 1 March 2005
File Size: 48.58 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 67724
Price: Free* [*Free Regsitration Required]

Using Copy Programs To check the specified settings of a program Touch [Check], and then touch the number of the program that you wish to check. 8301 Be careful not to touch the surface of the paper take-up roller with your hands. Indicates the amount of paper remaining.

Touch [Enter], and then touch [Enter] again in the screen that appears. When The Message “replace Xxxx. Close the right-side door of the large capacity tray.

KONICA MINOLTA INSTRUCTION MANUAL Pdf Download.

Duplexing Document Feeder Used for connecting the duplexing document feeder hookup connector cord. The sound pressure level at the operator position according to EN is equal to or less than 70 dB A. Touch [Color Shift Correction Y ] and repeat the same procedure for the yellow shift.

  HUAWEI USB NDIS MINIPORT DRIVER

Insert the hole-punch waste container into its original position. When a test print is printed, the mode returns to the 831 before the test print was performed. Pull up the staple case. Mode screen appears again. Indicates that there is little paper remaining.

Konica Minolta 8031 Instruction Manual

All color modes Black: The minnolta pattern is printed on the A3-size paper. Securely insert each charger-cleaning tool, and then close the front door. Transporting The Copier Use only toner that has been manufactured specifically for this copier.

Remove any paper, and then close the cover of the horizontal transport unit. If the top margin is more than 5. Pull out the empty toner cartridge. Primary paper output tray Collects copies that are not sorted.

Konica Minolta Toner Cartridges & Supplies

Peel off the tape. Total number of monotone copies Copy Size: The default setting is [ON].

Return the shutter of the staple cartridge to its original position. Dust remover Collects the dust generated in the copier.

  FLEXICAM 350K DRIVER DOWNLOAD

Instead, keep them in their boxes to be collected by your authorized service representative.

To replace the staple cartridge for FS Slide the finisher away from the copier. The specified limits are applied. When the Malfunction detected screen is displayed, be sure to contact your authorized service representative immediately by following the procedure below. Pull out toward you the two staples jammed at the end of the staple cartridge.

When The Message “replace The Toner Cartridge” Appears Do not replace the toner cartridge until the message indicating that it be replaced appears in the touch panel. Close the left-side and right-side misfeed-clearing mknolta. Scanner connector Used for connecting the scanner hookup cord. These functions are used to make fine adjustments to the print area margins of a printed image.